...
A train has to reserve all blocks till he it reaches a "save" place. It is not allowed to leave, if one of this blocks is already reserved. Only he it should be allowed to change switches and power on the reserved blocks.
Before entering a new block a train should set the corresponding signals and switches. The speed for a block should be set before entering it. At this time it should have the same speed as the block the train is leaving.
...
To change the current block a train has to reserve all blocks until he it reaches a save place to stay (e.g. all blocks until the holding track in KH). If he it is successful, he it has to set all switches and signals on his track. It sets only the signals of the block that it is currently about to enter and sets the speed of all blocks. To accelerate the speed has to be set synchronous on all used blocks. A train has to get slower before it should break, otherwise it might stop in the next segment. It should get slower, upon triggering the first contact of a block and stop upon triggering the second. The train releases all blocks after completely leaving them (the signal is set to red and the speed to 0). Upon reaching his its save place, a train has to check whether he it can continue. If this is not possible it must stop at the second contact.
...